Getting started

If you're new to Blink, begin by downloading the Blink app and creating your account. Once you have completed these steps, you can proceed with setting up your accessory.

Setting up and installing Blink Solaris

Before setting up Blink Solaris, you'll need a Sync Module and one of the following compatible cameras:

• Blink Outdoor 2K+
• Blink Outdoor 4

Once your Sync Module and camera are set up, you can proceed with setting up Blink Solaris in the Blink app.

1. From the Home Screen, tap the + icon in the upper-right corner.
2. Select Solaris Battery Pack from the list of devices.
3. Tap the camera you'd like to use Blink Solaris with, then tap Connect To Camera From The List.
   • If you don't have a compatible camera set up yet, select Install New Camera and follow the in-app prompts.
4. If your camera has batteries, remove the back cover and AA batteries from your Blink Outdoor 2K+ or Outdoor 4 camera. Set the AA batteries aside, as they are no longer needed once Blink Solaris is connected. Tap Continue.
   Note: Removing the batteries will take the camera offline, but it will remain attached to your account and power back on with Blink Solaris.
5. Align Blink Solaris with the back of the camera and slide it in until it connects. Tighten the screw in the middle of Blink Solaris and ensure the battery pack fits snugly, then tap Continue.
   
6. Place the back cover of the camera onto the exposed back of the battery pack. If the LED on the front of the camera does not blink within 30 seconds, check the connection between the battery pack and the camera, then tap Finish. To view mounting instructions in the Blink app, tap See Mounting Instructions.
   
7. Tap Complete Setup.

Mounting Blink Solaris

Before mounting, keep these placement guidelines in mind:

• Choose a location that receives direct sunlight for at least 45 minutes daily.
• Place the camera within range of the Sync Module so it can maintain a reliable connection.
• Mount up to 10ft (3m) high and position the camera to capture side-to-side movement.

To mount Blink Solaris:

1. Attach the mounting plate to the wall. Secure the mounting plate using the provided screws.
   
2. Once the base is secured, press the camera onto the mounting point until it clicks into place.
   

If you experience any issues during this process, visit Blink Solaris Troubleshooting.